Renovating your bathroom is never fun, and it can get expensive. What is the average cost to renovate the bathroom? It depends on your home but don’t panic if you are not an accomplished do-it-yourselfer, it’s very simple to do renovations and install a sink by yourself. It is also planned to be installed on a piece of furniture of the same size. This should not be a problem for you. Have a kit (available at any DIY store), and follow these steps.

1) Observe the furniture under sink

In order to be sure that you can start installing your sink , we advise you to review your sink cabinet. Have you identified the different supply ducts (hot water, cold water)? Is your piece of furniture perfectly horizontal? Use a spirit level in the four corners of the cabinet to check it. If it is horizontal, you can start installing your sink.

2) Drill the sink

faucetAs you may have noticed, you now need to drill the sink to run the faucet. Do not poke from below, you could damage your sink. If your sink is stainless steel, use a cookie cutter to drill the hole for the mixer or mixer. If your sink is sandstone, gently and gently drill small holes, until you can make a hole large enough to pass the faucet.

3) Install the drain from the sink

Put a seal or some sanitary sealant to make it tight. Then place your sink with attachment riders, which are normally provided with your kit. Finally, connect the faucet to the pipes and the drain hose to the siphon.

Reminder: we advise you to circulate a little hot water to check the tightness of the whole.